Design characteristics

• Wide modules and eyelets for less soiling
• Hinges that open wide, wide channels on the underside
  and a continuous drive bar for an easy-to-clean design
• robust design and smooth, cut-resistant surface (depending on material)
• Special sprocket design with enhanced tooth engagement
  for excellent force transmission

Basic data

S6.1-0 FLT | 0 % Opening | Flat top

• Closed, smooth surface
• Flat top surface
• Easy-to-clean

S6.1-0 NTP | 0 % Opening | Nub top (round studs)

• Closed surface and round studs
• 6 % contact area
• Nub top surface for good release of wet and sticky products
• Easy-to-clean

S6.1-0 CTP

• Closed surface and pointed studs
• Cone top surface pattern for superior grip
• Easy-to-clean

S6.1-21 FLT | 21 % Opening | Flat top

• Open area (21 %) for excellent air circulation and drainage
• 58 % contact area (Largest opening: 1.9 x 11 mm/0.07 x 0.43 in
• Smooth surface
• Easy-to-clean

S6.1-23 FLT | 23 % Opening | Flat top

• Open area (23 %) for excellent air circulation and drainage
• 61 % contact area (Largest opening: 4.3 x 9.3 mm/0.17 x 0.37 in)
• Smooth surface
• Easy-to-clean

S6.1-36 FLT | 36 % Opening | Flat top

• Open area (36 %) for excellent air circulation and drainage
• 20 % contact area (Largest opening: 11.8 x 15.2 mm/0.46 x 0.6 in)
• Smooth surface
• Easy-to-clean

Sprockets

in different sizes with round or square sprocket bore

Profiles

in different heights and designs for inclines.

Side guards

in different heights for retention of bulk products

Hold Down Tabs

Hold Down Tabs for additional guiding

Pin Retained Rollers

For applications where low back pressure accumulation or product separation is required