• Two-component, silicat-based adhesive.
• Ideal for filling cracks and holes in mineral screed.
• Shipping unit contains 2 bags with 20 wave connectors each.
• Suitable on underfloor heating systems.
• For inside use.
• Very low VOC emission according to EMICODE EC 1 Plus.
• Declared by baubook, "ecological building product".

• Screed flanks must be solid and load-bearing.
• If necessary, widen cracks with a cutting disk, place cross sections approximately every 20 - 30 cm and vacuum them with a powerful industrial vacuum cleaner, insert wave connectors into the cross sections.
• In the event of defects, concerns must be reported in writing.

Before use, temper the product according to the processing conditions.

• Mix the resin with the hardener homogeneously. To do this, decant the entire contents of the hardener bottle into the resin, close the bottle and shake vigorously for approx. 15 seconds, do not stir!
• Cut off the tip of the bottle spout to match the width of the crack.
• Immediately pour the finished compound into the sucked out cracks or joints and smooth them with a spatula.
• Immediately after mixing, the material is thin-bodied and therefore ideally suited for narrow joints/cracks. After about 4 minutes (20°C) the material starts to become more viscous. In this paste-like form it is ideal for wider joints/cracks.
• In order to ensure subsequent adhesion of Eurocol levelling compounds or Eurocol adhesives, the repair resin must be sanded with dry Eurocol 846 quartz sand 0.4 - 1 mm when uncured.

Do not use after the end of the pot life (thickening of the product).

Working conditions:
Required surrounding temperature: min. 18°C.
Material and subfloor temperature: min. 15°C.
Relative humidity: 35 - 75%, recommended <65%.