• Ready to use, one-component, fast drying primer to prime and fill (in one step) absorbent and non-absorbent cement- and calcium sulphate (gypsum) based subfloors (screed), stonewood screed, ceramic tiles, wooden floorboards, parquet, mastic asphalt, gypsum
  based floor boards such as Fermacel, Knauf.
• For priming and levelling of slight irregularities and joints on ceramic tiles, planks, parquet, wooden composites, gypsum-based floor boards before levelling works.
• Adhesive promoter for levelling works on approved damp proof membrans.
• For indoor use.
• Very low VOC emission. EMICODE EC 1 Plus.
• Declared by baubook, "ecological building product".

Primer for:

• as a dust-binding primer on absorbent surfaces,
• as adhesion promoter on dense substrates,
• for filling slight unevenness and joints in ceramic tiles, parquet etc.,
• as a substitute for quartz sand blinding on Eurocol reactive primers approved for this purpose before filling or gluing work.

• The substrate must be pressure- and tension-resistant, permanently dry, free of cracks and dust, even and free of layers that reduce adhesion.
• Adhesion-reducing layers, old material residues must be removed by suitable mechanical measures in accordance with the specifications of DIN 18365/DIN 18356.
• Old fixed floors, such as ceramic tiles, terrazzo, stone floors, must be thoroughly cleaned and sanded matt after drying.
• Cracks or joints (except structural expansion joints) are to be closed with Eurocol Europlan 913 Silicate sealing compound.
• In case of defects, objections are to be reported in writing.

• Before use, stir and allow to come to room temperature. For longer breaks in work, stir again to achieve a homogeneous mixture.
• Apply undiluted and evenly on the prepared substrates. Avoid puddle formation to ensure even drying.
• In case of deeper joints, if necessary, apply a 2nd coat after about 30 - 60 minutes to reduce joint tilting of the following filler.
• After drying for about 1 - 2 hours, depending on the absorbency of the substrate, the room climate and the quantity applied, a second coat can be applied with Eurocol levelling compounds suitable for the substrate and adapted to the subsequent use.
  can be filled.
• When using as adhesion promoter on Eurocol reactive resin primers approved for this purpose, it must be ensured that the application is carried out on a surface of the reactive resin primer that has been cured without adhesive and roughened with a black pad.

Filling work must be carried out within 24 hours.

Use released Eurocol reactive primers for subsequent levelling over 5 mm. These must be sprinkled with quartz sand.

Processing conditions: