Choose your country

Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2
Pulldown 2

eurocol
658 WANDOFORTE

658

Levelling compound for the wall.

658-wandoforte.jpg
  • specification-uk.pdf

    specification-uk.pdf

  • 658-safety data sheet uk.pdf

    658-safety data sheet uk.pdf

  • dop-declaration-uk.pdf

    dop-declaration-uk.pdf

Product Typification

Levelling compound for the wall.
Basis : Cement-based powder with additives and a high synthetic binder content, to be mixed with water.
Colour : Grey.

Product advantages:
  • For in- and outdoor use 
  • Moisture-resistant 
  • Frost-resistant 
  • High final bond strength 
  • Easy to apply 
  • Low chromate
  • Layer thickness from 2 to 10 mm

Performances

Aging : 658 Wandoforte does not deteriorate with age.
Classification : CSIV according to NEN EN 998-1. Multifunction plaster mortar with an increased compressive strength and a reduced water absorbtion for use under ceramic tiles.
Consumption : Approx. 1.5 kg/m² per mm layer thickness.
End strength : 658 Wandoforte is sufficiently strong for the direct installation of heavy wall covering materials e.g. ceramic tiles and natural stone.

Application

Application:
For levelling and repairing cement-based and other stony walls, e.g. concrete, cellular concrete, lime-sand stone, plasters etc., on which tiles have to be fixed.

Working Process

Layer thickness : 658 Wandoforte can be applied in one layer thickness up to 10 mm.
Storage : Store cool and dry in unopened packaging.
Mixing ratio : Add 25 kg of 658 Wandoforte to 6 litres of water.
Processing time : Apply the mortar within 20 minutes.
Latency : Wait for 2-3 minutes. Thereafter stir once again.
Drying time : Minimum 12 hours. During this period the wall cannot be treated.
Shelf Life : 12 Months, in unopened packaging. After use close the open packaging well.
Application temperature : From 10° to 25 °C (surrounding and subfloor temperature).

* The mentioned values have been established in our laboratory and must be considered as guidelines in view of possible variations in climatic circumstances, subfloor compositions and layer thickness.

Consumption:
Approx. 1.5 kg/m² per mm layer thickness.

Substrate:
  • 658 Wandoforte can be applied on any type of cement-based subfloor that is rigid and has a good tensile and compression strength. The subfloor should also be clean, dry and free from grease and dirt. 
  • In advance degrease impervious subfloors e.g. old wall tiles with 014 Euroclean. Thereafter dry completely.
  • Prime smooth and impervious walls with 051 Europrimer Quartz (indoor application).
  • First remove loose paint and lime residues. 
  • PRime porous walls with 099 Dispersion Primer. 
  • Fill holes and cracks in advance. 
  • In advance always seek our technical data sheets. In doubt about the application ask for technical advice. 


User manual:
  • Add 25 kg of 658 Wandoforte to 6 litres of cool and clean tap water. 
  • Stir the mortar for 1 minute, by using an electric stirrer, to a smooth and homogeneous mixture. 
  • Wait for a few minutes, stir once again and apply the mortar within 20 minutes with a flat trowel.
  • First apply the mortar in a thin layer and thereafter apply the mortar wet in wet in the required layer thickness of maximum 10 mm.
  • For extra smoothing strickle off the wall with a wet trowel and finish within 60 minutes. 




Quality and guarantee

Environment and health

Safety and environment : Safety data sheets of Forbo Eurocol products according to EEG-guideline 91/155.
MSDS : For extensive information about safety and environment we refer to our website www.eurocol.nl.


Articles

ArticleDefinitionPackagingEAN-code
658Wandoforte 25 kg Bag 8 710345 658010