• Very high quality lacquer with excellent spreading properties.
• For very hard-wearing to extremely hard-wearing (as a 2C-system) coating of standardized parquet and linoleum floors used in sports floor constructions.
• Suitable for re-coating of used floor coverings.
• Certified according to German standard DIN 18032 in combination with sport floor maintenance 897 Euroclean Sport.
• Meets requirements of ÖISS guidelines concerning sliding friction and gloss level.
• Available in matt.
• For interior use.
• Emission tested building product according to DIBt principles. 
• Certified by baubook, "ecological building product".

• The sealed surfaces should be clean and without traces of oil, wax, silicone and other adhesion-reducing layers.

Parquet as a sports floor:

• Filling the open joints of the sanded floor is not recommended.
• Priming is necessary to reduce any possibilities for edge gluing.

Parquet glued all over:

• Joints are closed with suitable Eurocol joint sealant. The öne sanding depends on the type of wood.
• The surface and edge sanding must be levelled out by means of a sanding grid.
• Use a Eurocol primer with barrier effect (e.g. for exotic woods, smoked oak, etc.) or to minimise absorbency and edge gluing (e.g. upright lamella parquet, parquet on sprung øoors or on underøoor heating).
• Alternatively in many cases the product can be used as primer and top coat as one.

Linoleum:

• The surface of the linoleum is to be cleaned thoroughly with 891 Euroclean Basic followed by a neutralizing and a 12 hour drying time.

In case of defects, objections are to be reported in writing.

Before use, temper the product according to the processing conditions.

• Stir before use! 
• Add the appropriate lacquer to a mixing container. Use a scraper grid during application.
  • When using as a 2C system:
  • Mix the lacquer with Aqua LE hardener homogeneously by slowly pouring the hardener into the prepared sealing bucket and mixing homogeneously (approx. 2 minutes). Then allow to react for 10 minutes and mix again briefly.
  • Do not use after the end of the pot life (see technical data). There is no immediate end of pot life due to thickening!
• Application to be done with  a new, clean Eurocol Aqua microfiber roller.
• The application to avoid any footprints on the floor.
• Do not apply more than two roller coats of lacquer in one day.

Linoleum:

• The lining with suitable game line marking color has to be carried out, when the cleaned linoleum has fully dried.
• A saturated varnish application needs to be done by Eurocol microfiber roller (length of fiber: 11 mm), onto thoroughly cleaned and dried linoleum. Take into account the recommended time frame for re-coating of applied game line marking color given by its manufacturer.
  

Parquet:

• To achieve uniform surface, apply the lacquer twice cross-wise or a uniform roller application with subsequent top coat application with roller. Eurocol recommends 2 roller applications.
• In the same day, do not apply the product more than twice.
• Drying time in-between layers is approx. 4 hours but not more than 24 hours.
• The surface needs to be sanded with an abrasive grid 100 or 120. Remove the dust with an industrial vacuum cleaner.
  Intermediate sanding improves the surface finish. Remove dust remains on the sanded surface.
• Line marking with suitable playing field markings is carried out after application of the last coat of varnish (on top), but can also be carried out before the last varnish application (embedded).
• During the drying process, even ventilation must be ensured. Draughts and direct sunlight must be avoided.

Recommended primers:

Eurocol 883 Europrime Perfect   
Rollable and trowelable, Low side-bonding. High neutrality of the wood tone. Long wet-on-wet workability (rollability). No visible seams during rolling and filling

Working conditions:
Required surrounding temperature: min. 18°C.
Material and subfloor temperature: min. 15°C.
Relative humidity: 35 - 75%, recommended <65%.