• Non-flammable
• Favourable spreading capacity
• Electrical resistance < 3.10⁵ Ohm (EN 13 415) 

• Primer for replacing the copper strip system when installing a conductive floor covering.
• In combination with conductive floor covering and conductive adhesives an adequate conductivity resistance will be achieved.
• Normally it is not necessary to apply and earth more than 1 m¹ of 801 Eurostrip EC per 30 m². Provide larger surfaces with a ring pipe, with each section is not larger than 30 m².
• 041 Europrimer EC is not suitable for application under Nora rubber.  

• 041 Europrimer EC is suitable for any type of subfloor that has a good tensile and compression strength. The subfloor should also be even, clean, permanently dry and free from grease and dirt, according to the requirements of BS 8203 or DIN 18 365.
• Under floor coverings it is always necessary to fill with a Eurocol levelling compound, adapted to the intended use, to ensure even and absorbent surfaces.
• Prime anhydrite floors with 049 Europrimer ABS, thereafter with 041 Europrimer EC.
• In advance always seek our technical data sheets. In doubt about the application ask for technical advice.

• Shake the primer well before use. 
• Apply 041 Europrimer EC evenly and covered with a lambswool roller and/or brush on the entire surface of the subfloor. 
• Always earth 041 Europrimer EC with 801 Eurostrip EC. Apply on every 30 m² 1 running metre 801 Eurostrip EC and ring pipe. On larger surfaces proportionally more copper strip should be used. The copper strips are to be earthed by an electrician. 
• Remove fresh spots immediately with water.

Working conditions:
Intended surrounding temperature : 18 - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 °C.
Relative humidity : 40 - 70%.